View all questions & answers for the NSE 4 - FortiOS 7.6 Administrator Exam Materials exam


Question 26 Discussion

When configuring a FortiGate in a multi-WAN setup, why would an administrator enable session preservation on an interface? (Choose one answer)

  • A. To allow the FortiGate to dynamically change interfaces for all active sessions when a WAN link fails
  • B. To make sure all sessions without source NAT enabled always use the primary WAN link
  • C. To improve security by forcing users to authenticate again when the WAN link changes
  • D. To ensure that existing SSL VPN connections remain on the same interface even if route changes occur
Correct Answer: D

Brave-Dump Clients Votes

D 100%

Comments



Capi 2025-10-31 01:36:19

Selected Answers: D


I'd say D but this is for all kind of traffic not only SSL VPN, that bothers me a bit

Anonymous User 2026-01-25 23:27:12

Selected Answers: D


The question is misleading because multi-WAN is typically discussed in the context of WAN failures, which is not mentioned here. Session preservation is used so that if routing changes occur on a dynamic WAN link, existing sessions remain on the original interface and are not dropped.