You configured an SD-WAN rule with the best quality strategy and selected the predefined health check, Default_FortiGuard, to check the link performances against FortiGuard servers. For the quality criteria, you selected Custom-profile-1. Which factors does FortiGate use, and in which order, to determine the link that it should use to steer the traffic? (Choose one answer)

A. Link quality index – Member configuration order – Link cost threshold
B. Latency – Member configuration order – Link cost threshold
C. Links that meet the SLA targets – Member configuration order – Member local cost
D. Latency – Jitter – Packet loss – Bandwidth – Member configuration order

Correct Answer: A

Brave-Dump Clients Votes

A 100%

Comments

Brave-Dumps Admin 2025-06-13 21:38:38

Selected Answers: A

As per FCSS - SD-WAN 7.4 Architect Study Guide page: 227

“FortiGate determines the member with the best quality using three factors:
member configuration order, the link-cost-threshold setting, and the value of the metric measured for the member.”

Jonathan 2025-08-12 02:47:45

Selected Answers: A

Hello Omar,

would u please confirm if answer is A because Custom-profile-1. is used or because Best Quality in General ? i think it's because the Custom-profile-1. is applied which is concerned with Link-quality-Index

Brave-Dumps Admin 2025-08-12 13:12:59
please check FCSS - SD-WAN 7.4 Architect Study Guide page: 227, It’s actually A because of how Best Quality works in general, not just because you used Custom-profile-1. The custom profile only defines how the Link Quality Index is calculated, but the decision order (Link Quality Index → Member config order → Link cost threshold) is part of the Best Quality logic itself.