Refer to the exhibits. An administrator admin used the Configuration Revision History window to revert the FortiGate device configuration to revision ID 6. After running the reinstall policy package, the administrator noticed problems with the firewall policy—they could not see the unset comment on policy ID 1. Why did FortiManager not remove the comment from policy ID 1 when the administrator ran reinstall policy package? (Choose one answer)

A. Because the administrator student must install the configuration changes to correctly see the expected results.
B. Because the administrator must import the firewall policies to update the firewall policy package.
C. Because every time the administrator uses the revert config file, they must use the Install Wizard instead of running the reinstall policy package.
D. Because the administrator used the Revision Diff view, which shows what changed, not what will be installed.

Correct Answer: B

Brave-Dump Clients Votes

B 75%

D 25%

Comments

Saeed Abd El Halim Hamada 2025-07-17 15:50:37

Selected Answers: B

Correct Answer: B
Why ?
Reverting the configuration on the FortiGate directly does not update FortiManager’s internal policy package.
FortiManager does not automatically sync with what’s on the FortiGate device after a manual configuration revert or change directly on the FortiGate.

Anonymous User 2026-05-04 23:46:14

Selected Answers: D

Correct ans is D

Anonymous User 2026-05-05 16:41:01

Selected Answers: B

ALI HASAN 2026-06-18 10:49:41

Selected Answers: B

The correct answer is B. The FortiManager 7.6 Administrator Study Guide says: ''Performing a revert operation followed by an installation only reverts device-level changes and does not revert policy packages. To achieve full synchronization, you must run the Import Configuration tool on FortiManager to synchronize the policy package.''

The guide also states: ''After every retrieve, auto-update, or revert operation, you must use Import Configuration to ensure the policy information is synchronized.''

In the exhibit, the missing unset comment for policy ID 1 is a policy package issue, not just a device-level revert issue. Reinstalling the existing policy package does not automatically rebuild it from the reverted revision. The administrator must import the firewall policies again so the policy package reflects the reverted policy state. That is why the comment was not removed.