View all questions & answers for the NSE 6 - Network Security 7.6 Support Engineer Materials exam


NSE 6 - Network Security 7.6 Support Engineer Materials-Question 100 Discussion

Refer to the exhibit, which contains a screenshot of some phase 1 settings. The VPN is not up. To diagnose the issue, the administrator enters the following CLI commands on an SSH session on FortiGate: Diagnose vpn ike log-filter dst-addr4 10.0.10.1 Diagnose debug application ike -1 However, the IKE real-time debug does not show any output. Why? (Choose one answer)

  • A. The administrator must also run the command diagnose debug enable.
  • B. The debug shows only error messages. If there is no output, then the phase 1 and phase 2 configurations match.
  • C. The log-filter setting is incorrect. The VPN traffic does not match this filter.
  • D. Replace diagnose debug application ike -1 with diagnose debug application ipsec -1.
Correct Answer: A

Brave-Dump Clients Votes

A 100%

Comments



Anonymous User 2026-04-05 01:28:58

Selected Answers: A


Network_Security_Support_Engineer_7.6_Study_Guide page 359