View all questions & answers for the FCP - FortiManager 7.4 Administrator Exam Materials exam


Question 34 Discussion

Refer to the exhibit. An administrator has created a firewall address object that is used in multiple policy packages for multiple FortiGate devices in an ADOM. After the installation operation is performed, which IP/netmask will be shown on FortiManager for this firewall address object? (Choose one answer)

  • A. FortiManager generates an error for each FortiGate without a per-device mapping defined for that object
  • B. 192.168.1.0/24
  • C. FortiManager replaces the address object to none.
  • D. 192.168.1.0/28
Correct Answer: B

Brave-Dump Clients Votes

D 50%
B 50%

Comments



Mahboab Ali Ghaleb 2025-07-18 03:32:54

Selected Answers: D


per device mapping enabled for Local-Fortigate, So the object refers to 192.168.1.0/28.
The devices in the ADOM that do not have dynamic mapping for LOCAL_SUBNET have a default value of 192.168.1.0/24.
Attention: There is same question but added at the end the question as below:
After the installation operation is performed, which IP/netmask is shown on FortiManager for this firewall address object for devices without a Per-Device Mapping set?
Without a per-device Mapping, The correct answer is B

John Doe 2025-10-07 14:56:09

Selected Answers: B


The address showing in FMG should be B (192.168.1.0/24)
Doesn't matter if installed or not, its only asking about the address object in FMG