Refer to the exhibit. An engineer applies this configuration to R1: ip nat inside source static 192.168.10.17 192.168.27.42 Which command set should be added to complete the configuration? (Choose one answer)

• A. R1(config)# interface GigabitEthernet 0/0
  R1(config-if)# ip nat inside
  
  R1(config)# interface GigabitEthernet 0/1
  R1(config-if)# ip nat outside
• B. R1(config)# interface GigabitEthernet 0/0
  R1(config-if)# ip nat outside
  
  R1(config)# interface GigabitEthernet 0/1
  R1(config-if)# ip nat inside
• C. R1(config)# interface GigabitEthernet 0/0
  R1(config)# ip nat outside
  
  R1(config)# interface GigabitEthernet 0/1
  R1(config)# ip nat inside
• D. R1(config)# interface GigabitEthernet 0/0
  R1(config)# ip nat inside
  
  
  R1(config)# interface GigabitEthernet 0/1
  R1(config)# ip nat outside

Correct Answer: B

Brave-Dump Clients Votes