View all questions & answers for the BIG-IP Administration Data Plane Concepts (F5CAB2) exam
BIG-IP Administration Data Plane Concepts (F5CAB2) - Question #46 Discussion
Community Explanations & Comments (2)
Brave-Dumps.com Admin
10 months ago
Selected: D
Using a single LACP trunk with both VLANs tagged ensures link redundancy and proper VLAN separation across both interfaces.
Anonymous User
9 months ago
Selected: D
A Self IP in BIG-IP is an IP address assigned to the device itself on a particular network segment, which allows the BIG-IP to communicate with other devices (nodes, pools, gateways) on that network.
When you configure a Self IP, you must specify where it “lives” physically or logically on the device. That is done by associating it with a VLAN or a Trunk.
A. Interface ❌ – You don’t assign a Self IP directly to a physical interface. Interfaces can be part of a VLAN or a Trunk, and the Self IP attaches to that logical grouping.
B. Route ❌ – Routes define where traffic goes, not where the IP resides.
C. Trunk ❌ – A Self IP can be on a Trunk, but only indirectly. You actually assign the Self IP to a VLAN, and the VLAN may use a Trunk underneath.
D. VLAN ✅ – Correct.
When configuring a Self IP, you must assign it to a VLAN (or an interface indirectly through VLAN/Trunk).
✅ Correct Answer:
D. VLAN
Tip to remember:
“Self IP → VLAN. VLAN may use an Interface or Trunk underneath, but the Self IP always attaches to the VLAN.”
When you configure a Self IP, you must specify where it “lives” physically or logically on the device. That is done by associating it with a VLAN or a Trunk.
A. Interface ❌ – You don’t assign a Self IP directly to a physical interface. Interfaces can be part of a VLAN or a Trunk, and the Self IP attaches to that logical grouping.
B. Route ❌ – Routes define where traffic goes, not where the IP resides.
C. Trunk ❌ – A Self IP can be on a Trunk, but only indirectly. You actually assign the Self IP to a VLAN, and the VLAN may use a Trunk underneath.
D. VLAN ✅ – Correct.
When configuring a Self IP, you must assign it to a VLAN (or an interface indirectly through VLAN/Trunk).
✅ Correct Answer:
D. VLAN
Tip to remember:
“Self IP → VLAN. VLAN may use an Interface or Trunk underneath, but the Self IP always attaches to the VLAN.”
The network architecture for a BIG-IP consists of an external and internal VLAN with two interfaces connected to the upstream switch. The design requires fault tolerance in the case that one of the interfaces is down. Which deployment architecture meets these requirements? (Choose one answer)
Brave-Dump Community Votes