Cisco Certified Network Associate (CCNA 200-301) Exam Materials - Question #199 Discussion

Guidelines

Please use the “Tasks” and “Topology” tabs to complete this lablet.

Complete the tasks below:

Task 1

Configure 802.1q trunks between Sw1 and Sw2 on ports E0/0 and E0/1.

• Only permit VLANs 10 and 30 across the trunks.

Task 2

Using LACP, create a Port Channel between Sw1 and Sw2.

• Combine E0/0 and E0/1 into a Port Channel while leaving the trunk configurations intact.
• Assign number 10.
• Both links must negotiate.

Answers

On SW1:

configure terminal

interface range e0/0 - 1
 switchport trunk encapsulation dot1q
 switchport mode trunk
 switchport trunk allowed vlan 10,30
 channel-group 10 mode active
 no shutdown
exit

interface port-channel 10
 switchport trunk encapsulation dot1q
 switchport mode trunk
 switchport trunk allowed vlan 10,30
 no shutdown
exit

end
wr

On SW2

configure terminal

interface range e0/0 - 1
 switchport trunk encapsulation dot1q
 switchport mode trunk
 switchport trunk allowed vlan 10,30
 channel-group 10 mode active
 no shutdown
exit

interface port-channel 10
 switchport trunk encapsulation dot1q
 switchport mode trunk
 switchport trunk allowed vlan 10,30
 no shutdown
exit

end
wr

 

(Choose the correct answer)

Brave-Dump Community Votes

No community votes submitted yet. Be the first to vote!