View all questions & answers for the FCSS - SD-WAN 7.4 Architect Exam Materials exam

FCSS - SD-WAN 7.4 Architect Exam Materials - Question #53 Discussion

Comment Image Comment Image Comment Image
Question Diagram

Refer to the exhibits. The administrator configured a device blueprint and CLI scripts as shown in the exhibits, to prepare for onboarding FortiGate devices in the company’s stores. Later, a technician prepares a FortiGate 51G with a basic configuration and connects it to the network. The basic configuration contains the port1 configuration and the minimal configuration required to allow the device to connect to FortiManager. After the device first connects to FortiManager, FortiManager updates the device configuration. Based on the exhibits, which actions does FortiManager perform? (Choose one answer)

  • A. FortiManager updates the device configuration according to the selected templates. It applies the corp_st template first.
  • B. FortiManager does not update the port1 configuration because FortiManager does not change the configuration of interfaces with fgfm access.
  • C. FortiManager updates access rights only for port1. FortiManager cannot update the IP address because it was already set manually.
  • D. FortiManager updates the configuration of port1, port2, and port5. The three ports might get new IP addresses.
Correct Answer: D

Brave-Dump Community Votes

Answer: D (2 votes) 100%

Community Explanations & Comments (2)

michael 1 year ago
Selected: D
Answer B is not correct, because Enforce Device Configuration is on. That allows changes on fgfm port. Page 89 7.4 Study Guide. Still not sure what is the correct answer.
Brave-Dumps.com Admin 1 year ago
Dear Michael, thank you for sharing your experience with the Brave-Dumps community and improving the dump Accuracy & quality, you are doing a great job. I go to D
Pavol KUCHAR 1 year ago
Selected: D
"Enforce Device Configuration" in Blueprint settings says:
The initial or current FortiGate config will be replaced for those settings specified in the blueprint.
Anything outside the blueprint scope (e.g., other interfaces or settings not defined in the blueprint) should remain untouched.
Brave-Dumps.com Admin 1 year ago
thank you, Pavol, for sharing your experience with the Brave-Dumps community and improving the dump accuracy & quality, you are doing a great job.