Brave Dumps Community
NSE 5 - FortiSwitch 7.6 Administrator Exam Materials - Question 23 Discussion

Which QoS mechanism maps packets with specific class of service (COS) or Differentiated Services Code Point (DSCP) markings to an egress queue?

By: Francisco Javier Delgado Ibarr at April 29, 2026 1:44 AM

NSE 5 - FortiSASE and SD-WAN 7.6 Core Administrator Exam Materials - Question 29 Discussion

Which three factors about SLA targets and SD-WAN rules should you consider when configuring SD-WAN rules?

By: Diaa El-rayse at April 28, 2026 12:55 PM

NSE 5 - FortiSASE and SD-WAN 7.6 Core Administrator Exam Materials - Question 6 Discussion

Which two statements correctly describe what happens when traffic matches the implicit SD-WAN rule?

By: Diaa El-rayse at April 28, 2026 10:43 AM

NSE 5 - FortiSASE and SD-WAN 7.6 Core Administrator Exam Materials - Question 2 Discussion

Refer to the exhibit, which shows the SD-WAN rule status and configuration. Based on the exhibit, which change in the measured packet loss will make HUB1-VPN3 the new preferred member?

By: Diaa El-rayse at April 28, 2026 10:11 AM

NSE 6 – SD-WAN 7.6 Enterprise Administrator Exam Materials - Question 85 Discussion

Refer to the exhibit. To check the status of an SD-WAN topology using the FortiManager SD-WAN monitor menus, you place your mouse next to branch1_fgt and receive the output shown in the exhibit. Which conclusion can you draw from the output shown in the exhibit? Note From Brave-Dumps: on th...

By: Anonymous User at April 27, 2026 4:47 PM

NSE 6 – SD-WAN 7.6 Enterprise Administrator Exam Materials - Question 79 Discussion

You must configure SD-WAN rules for a direct internet access (DIA) setup using the FortiGate GUI. The page you use to configure the source and destination part of the rule appears as shown in the exhibit. Why does the GUI page not include an option to configure an application as the destination o...

By: Anonymous User at April 27, 2026 4:39 PM

NSE 6 – SD-WAN 7.6 Enterprise Administrator Exam Materials - Question 69 Discussion

Refer to the exhibits. The administrator increases the member priority on port2 to 20. Assuming the route egressing port2 is still valid, upon configuration changes and the receipt of new packets. Which two actions does FortiGate perform on existing sessions established over port2?

By: Anonymous User at April 27, 2026 4:27 PM

NSE 6 – SD-WAN 7.6 Enterprise Administrator Exam Materials - Question 66 Discussion

Refer to the exhibit. Which two conclusions can you draw from the output shown?

By: Anonymous User at April 27, 2026 4:10 PM

NSE 6 – LAN Edge 7.6 Architect Exam Materials - Question 46 Discussion

Refer to the exhibits. A company has multiple FortiGate devices deployed and wants to centralize user authentication and authorization. The administrator decides to use FortiAuthenticator to convert RSSO messages to FSSO, allowing all FortiGate devices to receive user authentication updates. A...

By: Anonymous User at April 27, 2026 3:31 PM

NSE 6 – SD-WAN 7.6 Enterprise Administrator Exam Materials - Question 12 Discussion

Refer to the exhibits. The administrator increases the member priority on port2 to 20. Upon configuration changes and the receipt of new packets, which two actions does FortiGate perform on existing sessions established over port2?

By: asa at April 27, 2026 1:49 PM

NSE 7 - Enterprise Firewall 7.6 Administrator Exam Materials - Question 70 Discussion

Refer to the exhibit. A FortiGate segmented into VDOMs is shown. You must ensure effective and accelerated internet access for all of the VDOMs in this enterprise network. How can you achieve this?

By: Anonymous User at April 26, 2026 8:54 AM

NSE 7 - Enterprise Firewall 7.6 Administrator Exam Materials - Question 66 Discussion

You must segment an enterprise network. Which two features could you use?

By: Anonymous User at April 26, 2026 8:39 AM

NSE 7 - Enterprise Firewall 7.6 Administrator Exam Materials - Question 64 Discussion

Refer to the exhibit. An administrator is deploying a hub and spokes network and using OSPF as dynamic protocol. Which configuration is mandatory for neighbor adjacency?

By: Anonymous User at April 26, 2026 8:36 AM

NSE 7 - Enterprise Firewall 7.6 Administrator Exam Materials - Question 63 Discussion

You want to scale the IBGP sessions and optimize the routing table in an IBGP network. Which parameter should you configure?

By: Anonymous User at April 26, 2026 8:28 AM

NSE 7 - Enterprise Firewall 7.6 Administrator Exam Materials - Question 62 Discussion

Refer to the exhibit. The network diagram shows the addition of Site 2 with an overlapping network segment to the existing VPN IPsec connection between the hub and Site 1. Which IPsec phase 2 configuration must you make on the FortiGate hub to enable equal-cost multi-path (ECMP) routing when m...

By: Anonymous User at April 26, 2026 8:25 AM

NSE 7 - Enterprise Firewall 7.6 Administrator Exam Materials - Question 60 Discussion

A FortiGate device using unified threat management (UTM) profiles is reaching resource limits, and you expect traffic in your enterprise network to increase. You received an additional FortiGate of the same model. Which two options should you consider using to integrate the additional FortiGat...

By: Anonymous User at April 26, 2026 8:17 AM

NSE 7 - Enterprise Firewall 7.6 Administrator Exam Materials - Question 59 Discussion

An administrator is designing an ADVPN network for a large enterprise with spokes that have varying numbers of internet links. They want to avoid a high number of routes and peer connections at the hub. Which method should be used to simplify routing and peer management?

By: Anonymous User at April 26, 2026 8:14 AM

NSE 7 - Enterprise Firewall 7.6 Administrator Exam Materials - Question 57 Discussion

If you configure set tcp-mss-sender and set tcp-mss-receiver in a firewall policy, how does it affect the size and handling of TCP packets in the network?

By: Anonymous User at April 26, 2026 7:52 AM

NSE 7 - Enterprise Firewall 7.6 Administrator Exam Materials - Question 56 Discussion

You configured the FortiGate devices in an enterprise network to join the Fortinet Security Fabric. You have a list of IP addresses that must be blocked by the data center firewall. This list is updated daily. How can you automate updates to the firewall policy to add the IP addresses from the da...

By: Anonymous User at April 26, 2026 7:50 AM

NSE 7 - Enterprise Firewall 7.6 Administrator Exam Materials - Question 55 Discussion

Refer to the exhibit. You need to modify the MED value advertised from FortiGate_1 to a BGP neighbor in the autonomous system, AS 30. Which parameter must you configure on FortiGate_1 to implement this?

By: Anonymous User at April 26, 2026 7:47 AM