FCSS - SD-WAN 7.4 Architect Exam Materials - Question #17 Discussion

An administrator configures SD-WAN rules for a DIA setup using the FortiGate GUI. The page to configure the source and destination part of the rule looks as shown in the exhibit. The GUI page shows no option to configure an application as the destination of the SD-WAN rule....

Jim Abshire • October 14, 2025 3:54 PM • Voted: B

FCSS - SD-WAN 7.4 Architect Exam Materials - Question #31 Discussion

Refer to the exhibit. An administrator is troubleshooting SD-WAN on FortiGate. A device behind branch1_fgt generates traffic to the 10.0.0.0/8 network. The administrator expects the traffic to match SD-WAN rule ID 1 and be routed over HUB1-VPN1. However, the traffic is routed ov...

Jim Abshire • October 13, 2025 11:17 PM • Voted: B, C

FCSS - SD-WAN 7.4 Architect Exam Materials - Question #20 Discussion

Refer to the exhibit: Two hub-and-spoke groups are connected through redundant site-to-site IPsec VPNs between Hub 1 and Hub 2. Which two configuration settings are required for the spoke A1 to establish an ADVPN shortcut with the spoke B2?

Jim Abshire • October 13, 2025 11:05 PM • Voted: B, C

FCSS - SD-WAN 7.4 Architect Exam Materials - Question #10 Discussion

What are two mandatory post-run tasks that must be performed after using the SD-WAN overlay template?

prem • October 13, 2025 9:07 AM • Voted: A, C

FCSS - SD-WAN 7.4 Architect Exam Materials - Question #9 Discussion

For your ZTP deployment, you review the CSV file shown in exhibit and note that it is missing important information. Which two elements must you change before you can import it into FortiManager?

prem • October 13, 2025 9:06 AM • Voted: B, C

FCSS - SD-WAN 7.4 Architect Exam Materials - Question #7 Discussion

Refer to the exhibit, Upon configuration changes and the receipt of new packets, which two actions does FortiGate perform on existing sessions established over port2?

prem • October 13, 2025 9:05 AM • Voted: D, E

FCSS - SD-WAN 7.4 Architect Exam Materials - Question #3 Discussion

Refer to the exhibit: Which action will FortiGate take if it detects SD-WAN members as dead?

prem • October 13, 2025 9:00 AM • Voted: A

FCSS - Network Security 7.4 Support Engineer Exam Materials - Question #42 Discussion

Refer to the exhibit, which shows a partial output of the fssod daemon real-time debug command: What two conclusions can you draw from the output?

Anh Huynh • October 13, 2025 5:09 AM • Voted: C, E

FCSS - Network Security 7.4 Support Engineer Exam Materials - Question #39 Discussion

Refer to the exhibit, which displays the output of a real-time debug. Which statement accurately describes this output?

Anh Huynh • October 13, 2025 5:02 AM • Voted: B

FCSS - Network Security 7.4 Support Engineer Exam Materials - Question #35 Discussion

Refer to the exhibit, which shows the output of a BGP debug command. What is the reason that the local FortiGate is not receiving any prefixes from its neighbors?

Anh Huynh • October 13, 2025 4:53 AM • Voted: C

FCSS - Network Security 7.4 Support Engineer Exam Materials - Question #18 Discussion

Refer to the exhibit, What needs to happen for the local router to be elected DR?

Anh Huynh • October 13, 2025 4:40 AM • Voted: B

FCSS - Network Security 7.4 Support Engineer Exam Materials - Question #67 Discussion

Refer to the exhibit, which shows the partial output of diagnose sys session stat. Which statement about the output shown in the exhibit is correct?

Anh Huynh • October 10, 2025 6:38 AM • Voted: A

FCSS - SD-WAN 7.4 Architect Exam Materials - Question #26 Discussion

When a customer delegates the installation and management of its SD-WAN infrastructure to an MSSP, the MSSP usually keeps the hub within its infrastructure for ease of management and to share costly resources. In which two situations will the MSSP install the hub in customer...

Jim Abshire • October 9, 2025 7:20 PM • Voted: B, C

NSE 6 - FortiManager 7.6 Administrator Exam Materials - Question #28 Discussion

After correcting a policy package configuration issue, you want to prevent administrators from repeating the mistake that caused the issue. Which FortiManager approach best meets this need?

Omar Ahmed ([email protected]) • October 9, 2025 5:24 AM • Voted: D

FCSS - SD-WAN 7.4 Architect Exam Materials - Question #72 Discussion

When you configure FortiGate for SD-WAN, what is the impact when you assign a priority to the SD-WAN members?

Jim Abshire • October 8, 2025 4:52 PM • Voted: D

NSE 6 - FortiManager 7.6 Administrator Exam Materials - Question #11 Discussion

What is the best explanation of how FortiManager helps with mass provisioning?

Omar Ahmed ([email protected]) • October 8, 2025 3:55 PM • Voted: C

NSE 6 - FortiManager 7.6 Administrator Exam Materials - Question #8 Discussion

Refer to the exhibits. FortiGate HQ-NGFW-1 downloads and validates FortiGuard databases from FortiManager, which acts as a local FortiGuard Distribution Server (FDS) in a closed network. An administrator pushes a new firewall policy with an intrusion prevention system (IPS) pr...

Omar Ahmed ([email protected]) • October 8, 2025 12:26 PM • Voted: B

FCSS - SD-WAN 7.4 Architect Exam Materials - Question #51 Discussion

Refer to the exhibit. How does FortiGate handle the traffic with the source IP 10.0.1.130 and the destination IP 128.66.0.125?

Daniel • October 5, 2025 9:23 PM • Voted: C

FCSS - SD-WAN 7.4 Architect Exam Materials - Question #33 Discussion

Refer to the exhibit. Which SD-WAN rule and interface uses FortiGate to steer the traffic from the LAN subnet 10.0.1.0/24 to the corporate server 10.2.5.254?

KayPass • October 5, 2025 3:29 AM • Voted: A

FCSS - SD-WAN 7.4 Architect Exam Materials - Question #63 Discussion

Refer to the exhibit. The exhibit shows the health-check configuration on a FortiGate device used as a spoke. You notice that the hub FortiGate doesn’t prioritize the traffic as expected. Which two configuration elements should you check on the hub?

Jim Abshire • October 3, 2025 7:04 PM • Voted: A, C